3.6. Camera triggering

Warning

Up to v8 image, this setting cannot be applied to the C2 camera

You can input the camera-triggering pulse from the GMSL2-10GbE conversion module using the Trigger Settings tab

See also

• Frame synchronization specification of C1

• Frame synchronization specification of C2

Using the web interface, you can set the following parameters

• Trigger Mode

• Frequency

• Duty Cycle

• Offset

Caution

When you stream 8 cameras, it is important to set the offsets for P2, otherwise the signals interfere with one-another and serialization fails.

It is confirmed that 8 x C1 camera run stably up to 20Hz, by setting the offset parameters as below.

Camera	Offset
P2 / Port 1	15000000 (15msec)
P2 / Port 2	20000000 (20msec)
P2 / Port 3	25000000 (25msec)
P2 / Port 4	30000000 (30msec)

Do not forget to press Apply All at the end.