FAQs#
- 1. Automotive Camera
- 1.1. Can I adjust the camera settings such as exposure, gain, and shutter speed?
- 1.2. What are the options for C1 camera Field of View (FOV)?
- 1.3. What are the options for C2 camera Field of View (FOV)?
- 1.4. What is the camera size of C1 for each lens?
- 1.5. What is the camera size of C2 for each lens?
- 1.6. Can I change the frame rate?
- 1.7. What is the shutter type?
- 1.8. Does the camera have a zoom function?
- 1.9. Can I switch the shutter mode between rolling and global?
- 1.10. What’s the maximum length of the cable I can use?
- 1.11. Can I use a different ECU other than the recommended one?
- 1.12. What is the image delay from the camera to the ECU?
- 1.13. Is it possible to communicate and supply power with PoE?
- 1.14. Can I use the cameras with a USB interface?
- 1.15. Is it compatible with PTP IEEE1588?
- 1.16. How do I install the camera driver?
- 1.17. How can I inquire about products and services?
- 1.18. What should I do if the product is defective or malfunctions?
- 1.19. What is the operating temperature range of the cameras?
- 1.20. Is exterior CAD data available?
- 1.21. What environmental standards do the cameras comply with?
- 1.22. Can I use the C1 and C2 at the same time, with the same ECU?
- 1.23. Can I use the Raspberry pi to receive the data from the TIER IV cameras by using GMSL2-USB3.0 converter?
- 1.24. Can I fix the relationship between the GMSL port number and the device name?
- 1.25. Some cameras don’t start streaming image when I connect multiple (for instance, 8) cameras. This happens occasionally
- 2. Sensor Fusion System
- 2.1. Is the software for performing sensor fusion publicly available?
- 2.2. How can I find step-by-step instructions to build the kit?
- 2.3. Will it work even with sensor configurations different from the sample configuration?
- 2.4. Will it work even with ECU configurations different from the sample configuration?
- 2.5. Why do you need a camera and Lidar synchronization? How do you synchronize?
- 2.6. What is calibration? Why do you need calibration?
- 2.7. Does the provided software (sample application) work on Windows and Mac operating systems?
- 2.8. If I purchase from an authorized distributor, will the sensor drivers be pre-installed?
- 2.9. Can I purchase the board required for calibration?
- 2.10. I would like to ask for technical support for introduction, is it possible?
- 3. GMSL2-10GbE Conversion Module